Replacing Feet in Stands

• Use an 1/8" Roll Pin Punch to punch out the roll pin that is holding the foot into the stand.

• Remove the old food from the bottom of the stand.

To do this you can use a screwdriver to pry out the old food, you can also use a screwdriver with the flathead bit and a hammer to create a hole that you can then pry out the plastic with. You can also use a matte knife to cut the side of the foot and get it off.

• Pound the new feet in with a hammer.

• Drill the roll pin hole out with an 1/8" drill bit.

• Using the roll pin seating tool pound the new roll pin in.