Repairing Camlok Cable
Jump to navigation
Jump to search
- Remove old camlok hardware
If there are sodered connections you will have to but off the ends.
- Cut boot to correct size for wire
Slip boot on over cable
- Measure using the shim how far to cut the cable back
- Wrap shim tightly over copper wires
- Apply strain relief
2 half turns then tuck it into the shim, cut off exxess
- Install Cam hardware onto cable
use a rubber mallet
- Install set screws
- Spray lubricant inside boot and on Camlock
- Replace rubber boot
- Install plastic keeper screw